Evaluation of physicochemical properties of extracted cellulose from the walnut shell using ‎non-thermal plasma pretreatment

Authors
Isfahan University of Technology
Abstract
The present study aims to extract cellulose fibers from the walnut shell using dielectric barrier discharge (DBD) plasma pretreatment and to evaluate its properties. For this purpose, powdered walnut shells were exposed to 18 and 20 kV DBD plasma for 10 min in three stages. First, before sodium hydroxide alkaline treatment, next, before sodium chlorite bleaching treatment, and then, before both alkaline and bleaching treatments. The extraction efficiency, FTIR, XRD, thermal properties, FESEM and diameters of the cellulose fiber were evaluated. Based on the results, the extraction efficiency was significantly affected by applied voltage (p<0.05) and due to plasma destruction of glycosidic, the efficiency was reduced. The removal of peaks related to impurities from the walnut shell and the purity of all extracted cellulose was confirmed with FTIR. The results showed that applying DBD plasma during cellulose extraction did not affect its crystal structure, but the reduction of crystallization index was observed. Furthermore, the effect of plasma on the thermal-gravimetry of the samples was observed at temperatures below 100 ° C, and after the onset temperature of degradation, the behavior of the treated and untreated fibers until the final thermal decomposition was not significantly different. The microstructure of plasma-treated samples showed an increase in cellulose fiber's roughness and swelling, followed by the transformation of microfibrils to nanofibrils with a diameter of 80 nm at the higher voltage. In general, the results showed that applying 20 kV DBD plasma in both stages before the alkaline and delignification process is a more suitable treatment for extracting cellulose and producing cellulose nanofibers.
Keywords

Subjects


‎‎[1] Trache, D., Hussin, M.H., Chuin, C.T.H., Sabar, S., Fazita, M.N., Taiwo, O.F., Hassan, T, and Haafiz, M.M, ‎‎2016, Microcrystalline cellulose: Isolation, characterization and bio-composites application—A review, ‎International Journal of Biological Macromolecules, 93:789-804‎‌.‌
‎[2] Merci, A., Urbano, A., Grossmann, M.V.E, Tischer, C.A., and Mali, S., 2015, Properties of microcrystalline ‎cellulose extracted from soybean hulls by reactive extrusion, Food Research International, 73:38-43‎‌.‌
‎[3] Okhamafe, A., Igboechi, A., Obaseki T, 1991, Celluloses extracted from groundnut shell and rice husk 1: ‎preliminary physicochemical characterization, Pharm World J, 8(4):120-130‎‌.‌
‎[4] Ting, S.S., 2019, Comparative Properties Analysis between Microcrystalline Cellulose and Cellulose ‎Nanocrystals Extracted From Rice Straw, Malaysian Journal of Microscopy, 15(1):146-154‎‌.‌
‎[5] Katakojwala, R, Mohan, S.V., 2020, Microcrystalline cellulose production from sugarcane bagasse: Sustainable ‎process development and life cycle assessment, Journal of Cleaner Production, 249:119342‎‌.‌
‎[6] Ren, H., Shen, J., Pei, J., Wang, Z., Peng,‎‌ ‌Z., Fu, S., and zheng, Y., 2019, Characteristic microcrystalline ‎cellulose extracted by combined acid and enzyme hydrolysis of sweet sorghum, Cellulose, 26(15):8367-8381‎‌.‌
‎[7] Pérez, J., Munoz-Dorado, J., De la Rubia, T., Martinez, J., 2002, Biodegradation and biological treatments of ‎cellulose, hemicellulose, and lignin: an overview, International Microbiology, 5(2):53-63‎‌.‌
‎[8] Nguyen, X.T., 2006, Process for preparing microcrystalline cellulose. US. Patent 7005514‎‌.‌
‎[9] Junadi, N., Beg, M., Yunus, R.M., Ramli, R., Zianor Azrina, Z., Moshiul Alam, A., 2019,‎‌ ‌Characterization of ‎microcrystalline cellulose isolated through the mechanochemical method, Indian Journal of Fibre & Textile ‎Research (IJFTR),44(4):442-449‎‌.‌
‎[10] Stupińska, H., Iller, E., Zimek, Z., Wawro, D., Ciechańska, D., Kopania, E., et al, 2007, An environment-‎friendly method to prepare microcrystalline cellulose, Fibres & Textiles in Eastern Europe, 15:167--72‎‌.‌
‎[11] Bárdos, L., Baránková, H., 2010, Cold atmospheric plasma: Sources, processes, and applications. Thin Solid ‎Films, 518(23):6705-6713‎‌.‌
‎[12] Pankaj, S., Wan, Z., Keener, K., 2018, Effects of cold plasma on food quality: A review, Foods,7: 4‎‌.‌
‎[13] Pankaj, S., Thomas, S., 2016, Cold plasma applications in food packaging, Cold Plasma in Food and ‎Agriculture: Elsevier, 293-307‎‌.‌
‎[14] Tendero, C., Tixier, C., Tristant, P., Desmaison, J., Leprince, P., 2006, Atmospheric pressure plasmas: A ‎review, Spectrochimica Acta Part B: Atomic Spectroscopy, 61(1):2-30‎‌.‌
‎[15] Souza-Corrêa, J., Oliveira, C., Nascimento, V., Wolf, L., Gómez, E., Rocha, G., et al, 2014, Atmospheric ‎pressure plasma pretreatment of sugarcane bagasse: the influence of biomass particle size in the ozonation process,‎‌ ‌Applied biochemistry, and biotechnology, 172(3):1663-1672‎‌.‌
‎[16] Shaghaleh, H., Xu, X., Liu, H., Wang, S., Hamoud, Y.A., Dong, F., et al, 2019, The effect of atmospheric ‎pressure plasma pretreatment with various gases on the structural characteristics and chemical composition of ‎wheat straw and applications to enzymatic hydrolysis, Energy, 176:195-210‎‌.‌
‎[17] Hemmati, F., Jafari, S.M., Kashaninejad, M., Motlagh, M.B., 2018, Synthesis and characterization of cellulose ‎nanocrystals derived from walnut shell agricultural residues, International journal of biological macromolecules, ‎‎120:1216-1224‎‌.‌
‎[18] Kian, L.K., Jawaid, M., Ariffin, H., Alothman, O.Y., 2017, Isolation and characterization of microcrystalline ‎cellulose from roselle fibers, International journal of biological macromolecules, 103:931-940‎‌.‌
‎[19] Kumar, A., Negi, Y.S., Choudhary, V., Bhardwaj, N.K., 2014, Characterization of cellulose nanocrystals ‎produced by acid-hydrolysis from sugarcane bagasse as agro-waste, Journal of Materials Physics and Chemistry, ‎‎2(1):1-8‎‌.‌
‎[20] Macedo, M.J.P.d, 2018, Modification of‎‌ ‌kapok fibers by cold plasma surface treatment for the production of ‎composites of recycled polyethylene. Ph.D. Dissertation, Universidade Federal do Rio Grande do Note.‎
‎[21] Moosavinejad, S.M., Madhoushi, M., Vakili, M., Rasouli, D., 2019, Evaluation of degradation in chemical ‎compounds of wood in historical buildings using FT‌-‌IR and FT-Raman vibrational spectroscopy, Maderas Ciencia ‎y tecnología, 21(3):381-92‎‌.‌
‎[22] Bano, S., Negi, Y.S., 2017, Studies on cellulose nanocrystals isolated from groundnut shells, Carbohydrate ‎polymers, 157:1041-1049‎‌.‌
‎[23] Macedo, M.J., Silva, G.S., Feitor, M.C., Costa, T.H., Ito, E.N., Melo, J.D., 2020, Surface modification of kapok ‎fibers by cold plasma surface treatment. Journal of Materials Research and Technology, 9: 2467-2476‎‌.‌
‎[24] Shah, M.A., Khan, .M, Kumar, V., 2018, Biomass residue characterization for their potential application as ‎biofuels, Journal of Thermal Analysis and Calorimetry, 134(3):2137-2145‎‌.‌
‎[25] Ciolacu, D., Ciolacu, F., Popa, V.I., 2011, ‎‌ ‌Amorphous cellulose—structure and characterization, Cellulose ‎chemistry and technology, 45(1):13-2‎‌.‌
‎[26] Ţucureanu, V., Matei, A., Avram, A.M., 2016, FTIR spectroscopy for carbon family study, Critical reviews in ‎analytical chemistry, 46(6):502-520‎‌.‌
‎ [27] Debiagi, F., Faria-Tischer, P.C., Mali, S., 2020, Nanofibrillated cellulose obtained from soybean hull using ‎simple and eco-friendly processes based on reactive extrusion, Cellulose, 27(4):1975-1988‎‌.‌
‎[28] Gao, L., Li, D., Gao, F., Liu, Z., Hou, Y., Chen, S., et al, 2015, Hydroxyl radical-aided thermal pretreatment of ‎algal biomass for enhanced biodegradability, Biotechnology for biofuels, 8(1):1-11‎‌.‌
‎[29] Vanneste, J., Ennaert, T., Vanhulsel, A., Sels, B., 2017, Unconventional pretreatment of lignocellulose with ‎low‐temperature plasma, ChemSusChem, 10(1):14-31‎‌.‌
‎[30] Harini,‎‌ ‌K., Mohan, C.C., 2020, Isolation and characterization of micro and nanocrystalline cellulose fibers ‎from the walnut shell, corncob, and sugarcane bagasse, International Journal of Biological Macromolecules, ‎‎163:1375-1383‎‌.‌
‎[31] Trache, D., Donnot, A., Khimeche, K., Benelmir, R., Brosse, N., 2014, Physico-chemical properties and ‎thermal stability of microcrystalline cellulose isolated from Alfa fibres. Cabohydrate Polymers, 104:223-30‎‌.‌
‎[32] Kasiri, N., Fathi, M., 2018, Production of cellulose nanocrystals from pistachio shells and their application for ‎stabilizing Pickering emulsions, International journal of biological macromolecules, 106:1023-1031‎‌.‌
‎[33] Kian, L., Saba, N., Jawaid, M., Fouad, H., 2020, Characterization of microcrystalline cellulose extracted from ‎olive fiber, International journal of biological macromolecules, 156:347-353‎‌.‌
‎[34] Uzun, B., Yaman, E., 2015, Thermogravimetric pyrolysis of walnut shell an assessment of kinetic modeling. ‎International Conference on Industrial Waste and Waste Water Treatment Valorization, held in Athens, Greece ‎‎21st–23rd May‎‌.‌
‎[35] Kian, L.K., Saba, N., Jawaid, M., Fouad, H., 2020, Properties and characteristics of nanocrystalline cellulose ‎isolated from olive fiber, Carbohydrate Polymers, 241: 116423‎
‎[36] Abdullah, M., Nazir, M., Raza, M., Wahjoedi, B., Yussof, A., 2016, Autoclave and ultra-sonication treatments ‎of oil palm empty fruit bunch fibers for cellulose extraction and its polypropylene composite properties, Journal of ‎cleaner production, 126:686-697‎‌.‌
‎[37] Kusano, Y., Madsen, B., Berglund, L., Oksman, K., 2019, Modification of cellulose nanofibre surfaces by ‎He/NH 3 plasma at atmospheric‌ ‌pressure, Cellulose, 26(12):7185-7194‎‌.‌
‎[38] de Farias, J.G.G., Cavalcante, R.C., Canabarro, B.R., Viana, H.M., Scholz, S., Simão, R.A., Surface lignin ‎removal on coir fibers by plasma treatment for improved adhesion in thermoplastic starch composites, ‎Cabohydrate Polymers, 165:429-436‎
‎[39] Bundaleska, N., Tatarova, E., Dias, F., da Silva, M.L., Ferreira, C., Amorim, J., 2013, Air–water ‘tornado’-type ‎microwave plasmas applied for sugarcane biomass treatment, Journal of Physics D: Applied Physics, 47(5):055201‎‌.‌