Volume 16, Issue 89 (2019)                   FSCT 2019, 16(89): 237-247 | Back to browse issues page

XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

mirdeilami M, forghani M, bakhshabadi H, shirazi R. Optimization of oil extraction from peanut with ultrasonic pretreatment by using the response surface method (RSM). FSCT 2019; 16 (89) :237-247
URL: http://fsct.modares.ac.ir/article-7-25014-en.html
1- 1- Member of the Board of Kavardasht Agro-industry company, Aliabad-e- Katul, Iran
2- 2- Department of Food science and Tecnology,Gonbad Kavoos Branch, Islamic Azad University, Gonbad Kavoos,Iran , h.bakhshabadi@yahoo.com
Abstract:   (5459 Views)
In this research, in order to optimize the process of extraction of oil from the peanut using ultrasound pretreatment, three levels of sonication time (0, 30 and 60 min) were used. After using these pretreatments, the oil of seeds was extracted with screw press with different rotation speeds (11, 34 and 57 rpm), then parameters including oil extraction yield, acidity, oxidative stability, peroxide, total phenolic compounds and refractive index of the samples were studied. Statistical analysis and process optimization was performed with the use of response surface methodology (RSM). The results showed that with increasing sonication time, oil extraction yield and phenolic compounds increased first and then decreased. By increasing the speed of the screw press, the amount of oil extraction yield and oxidative stability decreased, but the acidity, peroxide and total phenolic compounds increased. Increasing the sonication time also resulted in increased acidity, oxidative stability and peroxide reduction. On the other hand, it was determined that the parameters did not affect the rate of refractive index and its rate was 1.471 for all measured samples. According to the results of process optimization, it might be stated that with applying 60 minutes of ultrasound time and screw-rotation speed of the press of 21.73 rpm can provide a 0.766 utility for extracting oil from peanut.
Full-Text [PDF 688 kb]   (2127 Downloads)    
Article Type: Brief Communication | Subject: Chemical Engineering of Food Industry
Received: 2018/09/11 | Accepted: 2019/06/23 | Published: 2019/07/15

Add your comments about this article : Your username or Email:
CAPTCHA

Send email to the article author


Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.